Concox JC270 GPS tracking setup
Connect your Concox JC270 to gTrack on the JT/T 808 (jt808) protocol (video over JT/T 1078 (jt1078)). This page lists its server settings and what gTrack reads from it. gTrack provides tracking software and does not sell trackers.
About the JC270
The JC270 is a Jimi IoT dashcam on JT/T 808, with video over JT/T 1078.
Concox JC270 server and port
| Tracker model | Concox JC270 |
|---|---|
| Server / hostname | tracker.uplisoft.com |
| Port | 5015 |
| Transport | TCP |
| Protocol | JT/T 808 (jt808) |
| Video (live and playback) | JT/T 1078 (jt1078), port 5263, TCP |
Enter the hostname without https:// and keep the port in its separate setting. Select TCP in your tracker configuration. Use the APN supplied by your SIM provider and check that mobile data is available.
What gTrack reads from the JC270
- ADAS alerts: forward collision, lane departure, headway and pedestrian warnings (9 types)
- DMS alerts: fatigue, phone use, smoking, distraction, seat belt and more (13 types)
- Jimi IoT extended alarms: 62 camera, driving and basic alarm codes, each by name
- Live video over JT/T 1078 (port 5263) and the photos the camera takes on an event or on request
- Status: ignition, battery and external voltage, GSM signal, satellites, fuel and temperature sensors
Add Concox JC270 to your fleet
- Add the vehicle
In gTrack click + Asset, give it a name and choose the tracker model.
- Enter the identifier
Use the IMEI or device identifier printed on your tracker. Add its SIM phone number and APN in the tracker form.
- Set the server
Configure your tracker to send to tracker.uplisoft.com using the model’s port and TCP or UDP transport shown below.
- Drive
The first position appears as soon as the tracker connects — usually within minutes.
In the tracker form, choose Concox JC270 and enter the identifier exactly as shown on your device. Saving these fields does not remotely reconfigure the tracker: apply the server settings using its manufacturer’s configuration tool or supported SMS commands.
From the first packet to the live map
Open the device Terminal in gTrack to check incoming packets and decoded reports. Confirm the identifier, APN, hostname, port and transport if the device remains offline. A device without a GPS fix may connect before it can show a valid position.
Once Concox JC270 sends valid data, use gTrack for live location, trip history, geofences and alerts. Fuel, ignition, temperature and other sensor values depend on the device, its wiring and firmware configuration.
Compare other Concox / Jimi IoT models or read the platform setup guide.
Other Concox / Jimi IoT models on JT/T 808 (jt808)
Concox JC181 · Concox JC182 · Concox JC371 · Concox JC450 · Concox JC450PRO · Concox JC451 · Concox JM-VL502 · Concox JM-VL533
Questions and answers
Which server and port does the JC270 use with gTrack?
Server tracker.uplisoft.com, port 5015, TCP, JT/T 808 (jt808) protocol. Video goes to port 5263 over JT/T 1078 (jt1078).
Does gTrack show the JC270's ADAS and DMS alerts?
Yes. Every ADAS and DMS alert type and every Jimi IoT alarm code is shown by its name, with live video and the alarm photos.
Do I need to buy the JC270 from gTrack?
No. gTrack is tracking software: connect the JC270 you already have.