Concox JC261 GPS tracking setup
Connect your Concox JC261 to gTrack on the gt06 protocol. This page lists its server settings, the SMS command and what gTrack reads from it. gTrack provides tracking software and does not sell trackers.
About the JC261
The JC261 is a Concox / Jimi IoT tracker on the GT06 protocol.
Concox JC261 server and port
| Tracker model | Concox JC261 |
|---|---|
| Server / hostname | tracker.uplisoft.com |
| Port | 5023 |
| Transport | TCP |
| Protocol | gt06 |
Enter the hostname without https:// and keep the port in its separate setting. Select TCP in your tracker configuration. Use the APN supplied by your SIM provider and check that mobile data is available.
Set the JC261 to send to gTrack
Send these two SMS commands to the tracker's phone number, your APN in place of <APN>. The tracker answers each one with a confirmation.
APN,<APN># SERVER,1,tracker.uplisoft.com,5023,0#
Some firmware versions use a different command format: check the manual of your model if the tracker does not confirm.
What gTrack reads from the JC261
- All 173 Jimi IoT alarm and event codes, each by name: SOS, tow, wire cut, door, airbag, rollover, jamming and more
- Status: ignition, external and battery voltage, battery level, GSM signal, satellites
- Driving: harsh acceleration, braking and cornering, collision, overspeed
Add Concox JC261 to your fleet
- Add the vehicle
In gTrack click + Asset, give it a name and choose the tracker model.
- Enter the identifier
Use the IMEI or device identifier printed on your tracker. Add its SIM phone number and APN in the tracker form.
- Set the server
Configure your tracker to send to tracker.uplisoft.com using the model’s port and TCP or UDP transport shown below.
- Drive
The first position appears as soon as the tracker connects — usually within minutes.
In the tracker form, choose Concox JC261 and enter the identifier exactly as shown on your device. Saving these fields does not remotely reconfigure the tracker: apply the server settings using its manufacturer’s configuration tool or supported SMS commands.
From the first packet to the live map
Open the device Terminal in gTrack to check incoming packets and decoded reports. Confirm the identifier, APN, hostname, port and transport if the device remains offline. A device without a GPS fix may connect before it can show a valid position.
Once Concox JC261 sends valid data, use gTrack for live location, trip history, geofences and alerts. Fuel, ignition, temperature and other sensor values depend on the device, its wiring and firmware configuration.
Compare other Concox / Jimi IoT models or read the platform setup guide.
Other Concox / Jimi IoT models on gt06
Concox AT3 · Concox AT4 · Concox CRX1 · Concox CT10 · Concox GK301 · Concox GK309 · Concox GS503 · Concox GT02
Questions and answers
Which server and port does the JC261 use with gTrack?
Server tracker.uplisoft.com, port 5023, TCP, gt06 protocol.
Which SMS sets the JC261 to gTrack?
APN,<APN># with your APN, then SERVER,1,tracker.uplisoft.com,5023,0#
Does gTrack show the JC261's alarms?
Yes, all 173 alarm and event codes of Jimi IoT's documentation, each by name, ready for rules and notifications.
Do I need to buy the JC261 from gTrack?
No. gTrack is tracking software: connect the JC261 you already have.