Concox CT10 GPS tracking setup
Connect your Concox CT10 to gTrack on the gt06 protocol. This page lists its server settings, the SMS command and what gTrack reads from it. gTrack provides tracking software and does not sell trackers.
About the CT10
The CT10 is a Concox / Jimi IoT tracker on the GT06 protocol.
Concox CT10 server and port
| Tracker model | Concox CT10 |
|---|---|
| Server / hostname | tracker.uplisoft.com |
| Port | 5023 |
| Transport | TCP |
| Protocol | gt06 |
Enter the hostname without https:// and keep the port in its separate setting. Select TCP in your tracker configuration. Use the APN supplied by your SIM provider and check that mobile data is available.
Set the CT10 to send to gTrack
Send these two SMS commands to the tracker's phone number, your APN in place of <APN>. The tracker answers each one with a confirmation.
APN,<APN># SERVER,1,tracker.uplisoft.com,5023,0#
Some firmware versions use a different command format: check the manual of your model if the tracker does not confirm.
What gTrack reads from the CT10
- All 173 Jimi IoT alarm and event codes, each by name: SOS, tow, wire cut, door, airbag, rollover, jamming and more
- Status: ignition, external and battery voltage, battery level, GSM signal, satellites
- Driving: harsh acceleration, braking and cornering, collision, overspeed
Add Concox CT10 to your fleet
- Add the vehicle
In gTrack click + Asset, give it a name and choose the tracker model.
- Enter the identifier
Use the IMEI or device identifier printed on your tracker. Add its SIM phone number and APN in the tracker form.
- Set the server
Configure your tracker to send to tracker.uplisoft.com using the model’s port and TCP or UDP transport shown below.
- Drive
The first position appears as soon as the tracker connects — usually within minutes.
In the tracker form, choose Concox CT10 and enter the identifier exactly as shown on your device. Saving these fields does not remotely reconfigure the tracker: apply the server settings using its manufacturer’s configuration tool or supported SMS commands.
From the first packet to the live map
Open the device Terminal in gTrack to check incoming packets and decoded reports. Confirm the identifier, APN, hostname, port and transport if the device remains offline. A device without a GPS fix may connect before it can show a valid position.
Once Concox CT10 sends valid data, use gTrack for live location, trip history, geofences and alerts. Fuel, ignition, temperature and other sensor values depend on the device, its wiring and firmware configuration.
Compare other Concox / Jimi IoT models or read the platform setup guide.
Other Concox / Jimi IoT models on gt06
Concox AT3 · Concox AT4 · Concox CRX1 · Concox GK301 · Concox GK309 · Concox GS503 · Concox GT02 · Concox GT02D
Questions and answers
Which server and port does the CT10 use with gTrack?
Server tracker.uplisoft.com, port 5023, TCP, gt06 protocol.
Which SMS sets the CT10 to gTrack?
APN,<APN># with your APN, then SERVER,1,tracker.uplisoft.com,5023,0#
Does gTrack show the CT10's alarms?
Yes, all 173 alarm and event codes of Jimi IoT's documentation, each by name, ready for rules and notifications.
Do I need to buy the CT10 from gTrack?
No. gTrack is tracking software: connect the CT10 you already have.