Cellocator Nano GPS tracking setup
Connect your Cellocator Nano to gTrack on the cellocator protocol. This page lists its server settings and what gTrack reads from it. gTrack provides tracking software and does not sell trackers.
Cellocator Nano server and port
| Tracker model | Cellocator Nano |
|---|---|
| Server / hostname | tracker.uplisoft.com |
| Port | 5033 |
| Transport | TCP / UDP |
| Protocol | cellocator |
Enter the hostname without https:// and keep the port in its separate setting. Choose TCP or UDP to match your device configuration. Use the APN supplied by your SIM provider and check that mobile data is available.
Add Cellocator Nano to your fleet
- Add the vehicle
In gTrack click + Asset, give it a name and choose the tracker model.
- Enter the identifier
Use the IMEI or device identifier printed on your tracker. Add its SIM phone number and APN in the tracker form.
- Set the server
Configure your tracker to send to tracker.uplisoft.com using the model’s port and TCP or UDP transport shown below.
- Drive
The first position appears as soon as the tracker connects — usually within minutes.
In the tracker form, choose Cellocator Nano and enter the identifier exactly as shown on your device. Saving these fields does not remotely reconfigure the tracker: apply the server settings using its manufacturer’s configuration tool or supported SMS commands.
From the first packet to the live map
Open the device Terminal in gTrack to check incoming packets and decoded reports. Confirm the identifier, APN, hostname, port and transport if the device remains offline. A device without a GPS fix may connect before it can show a valid position.
Once Cellocator Nano sends valid data, use gTrack for live location, trip history, geofences and alerts. Fuel, ignition, temperature and other sensor values depend on the device, its wiring and firmware configuration.
Compare other Cellocator models or read the platform setup guide.
Other Cellocator models on cellocator
Cellocator Cello-CANiQ · Cellocator Cello-F · Cellocator Cello-IQ · Cellocator Cello-R · CelloTrack · Cellocator 370-50 · Cellocator Compact CAN · Cellocator Compact Fleet
Questions and answers
Which server and port does the Nano use with gTrack?
Server tracker.uplisoft.com, port 5033, TCP / UDP, cellocator protocol.
Do I need to buy the Nano from gTrack?
No. gTrack is tracking software: connect the Nano you already have.