gTrack
PlatformLive GPS trackingTrip history & playbackAlerts & event rulesReportsGeofencesFuel & sensorsDrivers & behaviourFleet maintenanceVideo telematicsRemote commandsMobile appAI gTrack assistantAPI & integrations
SolutionsTransport & logisticsDelivery & courierConstruction & machineryTaxi & passenger transportCorporate fleetsCar rentalCold chainPublic sector & utilities
DevicesPricing
ResourcesGetting startedFAQSecurity & privacyPartners & resellers
CompanyAbout gTrackContact & quotePrivacy policyTerms of service
Request a quote
Teltonika connection guide

Teltonika FTM880 GPS tracking setup

Connect your Teltonika FTM880 to gTrack on the teltonika protocol. This page lists its server settings and what gTrack reads from it. gTrack provides tracking software and does not sell trackers.

About this model

About the FTM880

Specifications, manuals and firmware: official FTM880 documentation.

Connection settings

Teltonika FTM880 server and port

Tracker modelTeltonika FTM880
Server / hostnametracker.uplisoft.com
Port11445
TransportTCP / UDP
Protocolteltonika

Enter the hostname without https:// and keep the port in its separate setting. Choose TCP or UDP to match your device configuration. Use the APN supplied by your SIM provider and check that mobile data is available.

Configure the tracker

Set the FTM880 to send to gTrack

  1. Open Teltonika Configurator and connect the FTM880 with a USB cable or Bluetooth.
  2. In GPRS, set the APN of your SIM card.
  3. Under Server settings: Domain tracker.uplisoft.com, Port 11445, Protocol TCP.
  4. Save the configuration to the device. The first position arrives within a few minutes.
Setup

Add Teltonika FTM880 to your fleet

  1. Add the vehicle

    In gTrack click + Asset, give it a name and choose the tracker model.

  2. Enter the identifier

    Use the IMEI or device identifier printed on your tracker. Add its SIM phone number and APN in the tracker form.

  3. Set the server

    Configure your tracker to send to tracker.uplisoft.com using the model’s port and TCP or UDP transport shown below.

  4. Drive

    The first position appears as soon as the tracker connects — usually within minutes.

In the tracker form, choose Teltonika FTM880 and enter the identifier exactly as shown on your device. Saving these fields does not remotely reconfigure the tracker: apply the server settings using its manufacturer’s configuration tool or supported SMS commands.

Check the connection

From the first packet to the live map

Open the device Terminal in gTrack to check incoming packets and decoded reports. Confirm the identifier, APN, hostname, port and transport if the device remains offline. A device without a GPS fix may connect before it can show a valid position.

Once Teltonika FTM880 sends valid data, use gTrack for live location, trip history, geofences and alerts. Fuel, ignition, temperature and other sensor values depend on the device, its wiring and firmware configuration.

Compare other Teltonika models or read the platform setup guide.

FAQ

Questions and answers

Which server and port does the FTM880 use with gTrack?

Server tracker.uplisoft.com, port 11445, TCP / UDP, teltonika protocol.

Do I need to buy the FTM880 from gTrack?

No. gTrack is tracking software: connect the FTM880 you already have.