Teltonika ATM700 GPS tracking setup
Connect your Teltonika ATM700 to gTrack on the teltonika protocol. This page lists its server settings and what gTrack reads from it. gTrack provides tracking software and does not sell trackers.
About the ATM700
Specifications, manuals and firmware: official ATM700 documentation.
Teltonika ATM700 server and port
| Tracker model | Teltonika ATM700 |
|---|---|
| Server / hostname | tracker.uplisoft.com |
| Port | 11445 |
| Transport | TCP / UDP |
| Protocol | teltonika |
Enter the hostname without https:// and keep the port in its separate setting. Choose TCP or UDP to match your device configuration. Use the APN supplied by your SIM provider and check that mobile data is available.
Set the ATM700 to send to gTrack
- Open Teltonika Configurator and connect the ATM700 with a USB cable or Bluetooth.
- In GPRS, set the APN of your SIM card.
- Under Server settings: Domain
tracker.uplisoft.com, Port11445, ProtocolTCP. - Save the configuration to the device. The first position arrives within a few minutes.
Add Teltonika ATM700 to your fleet
- Add the vehicle
In gTrack click + Asset, give it a name and choose the tracker model.
- Enter the identifier
Use the IMEI or device identifier printed on your tracker. Add its SIM phone number and APN in the tracker form.
- Set the server
Configure your tracker to send to tracker.uplisoft.com using the model’s port and TCP or UDP transport shown below.
- Drive
The first position appears as soon as the tracker connects — usually within minutes.
In the tracker form, choose Teltonika ATM700 and enter the identifier exactly as shown on your device. Saving these fields does not remotely reconfigure the tracker: apply the server settings using its manufacturer’s configuration tool or supported SMS commands.
From the first packet to the live map
Open the device Terminal in gTrack to check incoming packets and decoded reports. Confirm the identifier, APN, hostname, port and transport if the device remains offline. A device without a GPS fix may connect before it can show a valid position.
Once Teltonika ATM700 sends valid data, use gTrack for live location, trip history, geofences and alerts. Fuel, ignition, temperature and other sensor values depend on the device, its wiring and firmware configuration.
Compare other Teltonika models or read the platform setup guide.
Other Teltonika models on teltonika
Teltonika AT1000 · Teltonika AT1200 · Teltonika ATC700 · Teltonika ATC704 · Teltonika ATC774 · Teltonika ATM704 · Teltonika ATM774 · Teltonika FM1000
Questions and answers
Which server and port does the ATM700 use with gTrack?
Server tracker.uplisoft.com, port 11445, TCP / UDP, teltonika protocol.
Do I need to buy the ATM700 from gTrack?
No. gTrack is tracking software: connect the ATM700 you already have.