gTrack
PlatformLive GPS trackingTrip history & playbackAlerts & event rulesReportsGeofencesFuel & sensorsDrivers & behaviourFleet maintenanceVideo telematicsRemote commandsMobile appAI gTrack assistantAPI & integrations
SolutionsTransport & logisticsDelivery & courierConstruction & machineryTaxi & passenger transportCorporate fleetsCar rentalCold chainPublic sector & utilities
DevicesPricing
ResourcesGetting startedFAQSecurity & privacyPartners & resellers
CompanyAbout gTrackContact & quotePrivacy policyTerms of service
Request a quote
Joint connection guide

Joint GP5000 GPS tracking setup

Connect your Joint GP5000 to gTrack on the jt600 protocol. This page lists its server settings and what gTrack reads from it. gTrack provides tracking software and does not sell trackers.

Connection settings

Joint GP5000 server and port

Tracker modelJoint GP5000
Server / hostnametracker.uplisoft.com
Port5014
TransportTCP
Protocoljt600

Enter the hostname without https:// and keep the port in its separate setting. Select TCP in your tracker configuration. Use the APN supplied by your SIM provider and check that mobile data is available.

Setup

Add Joint GP5000 to your fleet

  1. Add the vehicle

    In gTrack click + Asset, give it a name and choose the tracker model.

  2. Enter the identifier

    Use the IMEI or device identifier printed on your tracker. Add its SIM phone number and APN in the tracker form.

  3. Set the server

    Configure your tracker to send to tracker.uplisoft.com using the model’s port and TCP or UDP transport shown below.

  4. Drive

    The first position appears as soon as the tracker connects — usually within minutes.

In the tracker form, choose Joint GP5000 and enter the identifier exactly as shown on your device. Saving these fields does not remotely reconfigure the tracker: apply the server settings using its manufacturer’s configuration tool or supported SMS commands.

Check the connection

From the first packet to the live map

Open the device Terminal in gTrack to check incoming packets and decoded reports. Confirm the identifier, APN, hostname, port and transport if the device remains offline. A device without a GPS fix may connect before it can show a valid position.

Once Joint GP5000 sends valid data, use gTrack for live location, trip history, geofences and alerts. Fuel, ignition, temperature and other sensor values depend on the device, its wiring and firmware configuration.

Compare other Joint models or read the platform setup guide.

Similar models

Other Joint models on jt600

Joint JT600C · Joint JT600 · Joint JT701 · Joint JT701D · Joint JT702 · Joint JT705A · Joint JT707 · Joint JT707A

FAQ

Questions and answers

Which server and port does the GP5000 use with gTrack?

Server tracker.uplisoft.com, port 5014, TCP, jt600 protocol.

Do I need to buy the GP5000 from gTrack?

No. gTrack is tracking software: connect the GP5000 you already have.