gTrack
PlatformLive GPS trackingTrip history & playbackAlerts & event rulesReportsGeofencesFuel & sensorsDrivers & behaviourFleet maintenanceVideo telematicsRemote commandsMobile appAI gTrack assistantAPI & integrations
SolutionsTransport & logisticsDelivery & courierConstruction & machineryTaxi & passenger transportCorporate fleetsCar rentalCold chainPublic sector & utilities
DevicesPricing
ResourcesGetting startedFAQSecurity & privacyPartners & resellers
CompanyAbout gTrackContact & quotePrivacy policyTerms of service
Request a quote
GenX connection guide

GenX 5P GPS tracking setup

Connect your GenX 5P to gTrack on the genx protocol. This page lists its server settings and what gTrack reads from it. gTrack provides tracking software and does not sell trackers.

Connection settings

GenX 5P server and port

Tracker modelGenX 5P
Server / hostnametracker.uplisoft.com
Port5148
TransportTCP
Protocolgenx

Enter the hostname without https:// and keep the port in its separate setting. Select TCP in your tracker configuration. Use the APN supplied by your SIM provider and check that mobile data is available.

Setup

Add GenX 5P to your fleet

  1. Add the vehicle

    In gTrack click + Asset, give it a name and choose the tracker model.

  2. Enter the identifier

    Use the IMEI or device identifier printed on your tracker. Add its SIM phone number and APN in the tracker form.

  3. Set the server

    Configure your tracker to send to tracker.uplisoft.com using the model’s port and TCP or UDP transport shown below.

  4. Drive

    The first position appears as soon as the tracker connects — usually within minutes.

In the tracker form, choose GenX 5P and enter the identifier exactly as shown on your device. Saving these fields does not remotely reconfigure the tracker: apply the server settings using its manufacturer’s configuration tool or supported SMS commands.

Check the connection

From the first packet to the live map

Open the device Terminal in gTrack to check incoming packets and decoded reports. Confirm the identifier, APN, hostname, port and transport if the device remains offline. A device without a GPS fix may connect before it can show a valid position.

Once GenX 5P sends valid data, use gTrack for live location, trip history, geofences and alerts. Fuel, ignition, temperature and other sensor values depend on the device, its wiring and firmware configuration.

Compare other GenX models or read the platform setup guide.

Similar models

Other GenX models on genx

GenX 20

FAQ

Questions and answers

Which server and port does the 5P use with gTrack?

Server tracker.uplisoft.com, port 5148, TCP, genx protocol.

Do I need to buy the 5P from gTrack?

No. gTrack is tracking software: connect the 5P you already have.