gTrack
PlatformLive GPS trackingTrip history & playbackAlerts & event rulesReportsGeofencesFuel & sensorsDrivers & behaviourFleet maintenanceVideo telematicsRemote commandsMobile appAI gTrack assistantAPI & integrations
SolutionsTransport & logisticsDelivery & courierConstruction & machineryTaxi & passenger transportCorporate fleetsCar rentalCold chainPublic sector & utilities
DevicesPricing
ResourcesGetting startedFAQSecurity & privacyPartners & resellers
CompanyAbout gTrackContact & quotePrivacy policyTerms of service
Request a quote
Teltonika connection guide

Teltonika RUTC50 GPS tracking setup

Connect your Teltonika RUTC50, a Teltonika Networks router with GNSS, to gTrack on the teltonika protocol. This page lists its server settings and what gTrack reads from it. gTrack provides tracking software and does not sell trackers.

About this model

About the RUTC50

The RUTC50 is a Teltonika Networks router with GNSS by Teltonika.

Connection settings

Teltonika RUTC50 server and port

Tracker modelTeltonika RUTC50
Server / hostnametracker.uplisoft.com
Port11445
TransportTCP / UDP
Protocolteltonika

Enter the hostname without https:// and keep the port in its separate setting. Choose TCP or UDP to match your device configuration. Use the APN supplied by your SIM provider and check that mobile data is available.

Setup

Add Teltonika RUTC50 to your fleet

  1. Add the vehicle

    In gTrack click + Asset, give it a name and choose the tracker model.

  2. Enter the identifier

    Use the IMEI or device identifier printed on your tracker. Add its SIM phone number and APN in the tracker form.

  3. Set the server

    Configure your tracker to send to tracker.uplisoft.com using the model’s port and TCP or UDP transport shown below.

  4. Drive

    The first position appears as soon as the tracker connects — usually within minutes.

In the tracker form, choose Teltonika RUTC50 and enter the identifier exactly as shown on your device. Saving these fields does not remotely reconfigure the tracker: apply the server settings using its manufacturer’s configuration tool or supported SMS commands.

Check the connection

From the first packet to the live map

Open the device Terminal in gTrack to check incoming packets and decoded reports. Confirm the identifier, APN, hostname, port and transport if the device remains offline. A device without a GPS fix may connect before it can show a valid position.

Once Teltonika RUTC50 sends valid data, use gTrack for live location, trip history, geofences and alerts. Fuel, ignition, temperature and other sensor values depend on the device, its wiring and firmware configuration.

Compare other Teltonika models or read the platform setup guide.

FAQ

Questions and answers

Which server and port does the RUTC50 use with gTrack?

Server tracker.uplisoft.com, port 11445, TCP / UDP, teltonika protocol.

Do I need to buy the RUTC50 from gTrack?

No. gTrack is tracking software: connect the RUTC50 you already have.