Teltonika FM3620 GPS tracking setup
Connect your Teltonika FM3620, a tracker of Teltonika’s FM series, to gTrack on the teltonika protocol. This page lists its server settings and what gTrack reads from it. gTrack provides tracking software and does not sell trackers.
About the FM3620
The FM3620 is a tracker of Teltonika’s FM series by Teltonika.
Teltonika FM3620 server and port
| Tracker model | Teltonika FM3620 |
|---|---|
| Server / hostname | tracker.uplisoft.com |
| Port | 11445 |
| Transport | TCP / UDP |
| Protocol | teltonika |
Enter the hostname without https:// and keep the port in its separate setting. Choose TCP or UDP to match your device configuration. Use the APN supplied by your SIM provider and check that mobile data is available.
Set the FM3620 to send to gTrack
- Open Teltonika Configurator and connect the FM3620 with a USB cable or Bluetooth.
- In GPRS, set the APN of your SIM card.
- Under Server settings: Domain
tracker.uplisoft.com, Port11445, ProtocolTCP. - Save the configuration to the device. The first position arrives within a few minutes.
Add Teltonika FM3620 to your fleet
- Add the vehicle
In gTrack click + Asset, give it a name and choose the tracker model.
- Enter the identifier
Use the IMEI or device identifier printed on your tracker. Add its SIM phone number and APN in the tracker form.
- Set the server
Configure your tracker to send to tracker.uplisoft.com using the model’s port and TCP or UDP transport shown below.
- Drive
The first position appears as soon as the tracker connects — usually within minutes.
In the tracker form, choose Teltonika FM3620 and enter the identifier exactly as shown on your device. Saving these fields does not remotely reconfigure the tracker: apply the server settings using its manufacturer’s configuration tool or supported SMS commands.
From the first packet to the live map
Open the device Terminal in gTrack to check incoming packets and decoded reports. Confirm the identifier, APN, hostname, port and transport if the device remains offline. A device without a GPS fix may connect before it can show a valid position.
Once Teltonika FM3620 sends valid data, use gTrack for live location, trip history, geofences and alerts. Fuel, ignition, temperature and other sensor values depend on the device, its wiring and firmware configuration.
Compare other Teltonika models or read the platform setup guide.
Other Teltonika FM series trackers
Teltonika FM1000 · Teltonika FM1010 · Teltonika FM1100 · Teltonika FM1120 · Teltonika FM1125 · Teltonika FM1200 · Teltonika FM1202 · Teltonika FM2100
Questions and answers
Which server and port does the FM3620 use with gTrack?
Server tracker.uplisoft.com, port 11445, TCP / UDP, teltonika protocol.
Do I need to buy the FM3620 from gTrack?
No. gTrack is tracking software: connect the FM3620 you already have.