Teltonika AT2000 GPS tracking setup
Connect your Teltonika AT2000 to gTrack on the at2000 protocol. This page lists its server settings and what gTrack reads from it. gTrack provides tracking software and does not sell trackers.
Teltonika AT2000 server and port
| Tracker model | Teltonika AT2000 |
|---|---|
| Server / hostname | tracker.uplisoft.com |
| Port | 5128 |
| Transport | TCP |
| Protocol | at2000 |
Enter the hostname without https:// and keep the port in its separate setting. Select TCP in your tracker configuration. Use the APN supplied by your SIM provider and check that mobile data is available.
Set the AT2000 to send to gTrack
- Open Teltonika Configurator and connect the AT2000 with a USB cable or Bluetooth.
- In GPRS, set the APN of your SIM card.
- Under Server settings: Domain
tracker.uplisoft.com, Port5128, ProtocolTCP. - Save the configuration to the device. The first position arrives within a few minutes.
Add Teltonika AT2000 to your fleet
- Add the vehicle
In gTrack click + Asset, give it a name and choose the tracker model.
- Enter the identifier
Use the IMEI or device identifier printed on your tracker. Add its SIM phone number and APN in the tracker form.
- Set the server
Configure your tracker to send to tracker.uplisoft.com using the model’s port and TCP or UDP transport shown below.
- Drive
The first position appears as soon as the tracker connects — usually within minutes.
In the tracker form, choose Teltonika AT2000 and enter the identifier exactly as shown on your device. Saving these fields does not remotely reconfigure the tracker: apply the server settings using its manufacturer’s configuration tool or supported SMS commands.
From the first packet to the live map
Open the device Terminal in gTrack to check incoming packets and decoded reports. Confirm the identifier, APN, hostname, port and transport if the device remains offline. A device without a GPS fix may connect before it can show a valid position.
Once Teltonika AT2000 sends valid data, use gTrack for live location, trip history, geofences and alerts. Fuel, ignition, temperature and other sensor values depend on the device, its wiring and firmware configuration.
Compare other Teltonika models or read the platform setup guide.
Questions and answers
Which server and port does the AT2000 use with gTrack?
Server tracker.uplisoft.com, port 5128, TCP, at2000 protocol.
Do I need to buy the AT2000 from gTrack?
No. gTrack is tracking software: connect the AT2000 you already have.