gTrack
PlatformLive GPS trackingTrip history & playbackAlerts & event rulesReportsGeofencesFuel & sensorsDrivers & behaviourFleet maintenanceVideo telematicsRemote commandsMobile appAI gTrack assistantAPI & integrations
SolutionsTransport & logisticsDelivery & courierConstruction & machineryTaxi & passenger transportCorporate fleetsCar rentalCold chainPublic sector & utilities
DevicesPricing
ResourcesGetting startedFAQSecurity & privacyPartners & resellers
CompanyAbout gTrackContact & quotePrivacy policyTerms of service
Request a quote
Suntech connection guide

Suntech ST340UR GPS tracking setup

Connect your Suntech ST340UR to gTrack on the suntech protocol. This page lists its server settings and what gTrack reads from it. gTrack provides tracking software and does not sell trackers.

Connection settings

Suntech ST340UR server and port

Tracker modelSuntech ST340UR
Server / hostnametracker.uplisoft.com
Port5011
TransportTCP
Protocolsuntech

Enter the hostname without https:// and keep the port in its separate setting. Select TCP in your tracker configuration. Use the APN supplied by your SIM provider and check that mobile data is available.

Setup

Add Suntech ST340UR to your fleet

  1. Add the vehicle

    In gTrack click + Asset, give it a name and choose the tracker model.

  2. Enter the identifier

    Use the IMEI or device identifier printed on your tracker. Add its SIM phone number and APN in the tracker form.

  3. Set the server

    Configure your tracker to send to tracker.uplisoft.com using the model’s port and TCP or UDP transport shown below.

  4. Drive

    The first position appears as soon as the tracker connects — usually within minutes.

In the tracker form, choose Suntech ST340UR and enter the identifier exactly as shown on your device. Saving these fields does not remotely reconfigure the tracker: apply the server settings using its manufacturer’s configuration tool or supported SMS commands.

Check the connection

From the first packet to the live map

Open the device Terminal in gTrack to check incoming packets and decoded reports. Confirm the identifier, APN, hostname, port and transport if the device remains offline. A device without a GPS fix may connect before it can show a valid position.

Once Suntech ST340UR sends valid data, use gTrack for live location, trip history, geofences and alerts. Fuel, ignition, temperature and other sensor values depend on the device, its wiring and firmware configuration.

Compare other Suntech models or read the platform setup guide.

Similar models

Other Suntech models on suntech

Suntech ST200 · Suntech ST20 · Suntech ST210 · Suntech ST215 · Suntech ST230 · Suntech ST240 · Suntech ST300 · Suntech ST310U

FAQ

Questions and answers

Which server and port does the ST340UR use with gTrack?

Server tracker.uplisoft.com, port 5011, TCP, suntech protocol.

Do I need to buy the ST340UR from gTrack?

No. gTrack is tracking software: connect the ST340UR you already have.