ERM StarLink + CAN Bus GPS tracking setup
Connect your ERM StarLink + CAN Bus to gTrack on the starlink protocol. This page lists its server settings and what gTrack reads from it. gTrack provides tracking software and does not sell trackers.
ERM StarLink + CAN Bus server and port
| Tracker model | ERM StarLink + CAN Bus |
|---|---|
| Server / hostname | tracker.uplisoft.com |
| Port | 5136 |
| Transport | TCP |
| Protocol | starlink |
Enter the hostname without https:// and keep the port in its separate setting. Select TCP in your tracker configuration. Use the APN supplied by your SIM provider and check that mobile data is available.
Add ERM StarLink + CAN Bus to your fleet
- Add the vehicle
In gTrack click + Asset, give it a name and choose the tracker model.
- Enter the identifier
Use the IMEI or device identifier printed on your tracker. Add its SIM phone number and APN in the tracker form.
- Set the server
Configure your tracker to send to tracker.uplisoft.com using the model’s port and TCP or UDP transport shown below.
- Drive
The first position appears as soon as the tracker connects — usually within minutes.
In the tracker form, choose ERM StarLink + CAN Bus and enter the identifier exactly as shown on your device. Saving these fields does not remotely reconfigure the tracker: apply the server settings using its manufacturer’s configuration tool or supported SMS commands.
From the first packet to the live map
Open the device Terminal in gTrack to check incoming packets and decoded reports. Confirm the identifier, APN, hostname, port and transport if the device remains offline. A device without a GPS fix may connect before it can show a valid position.
Once ERM StarLink + CAN Bus sends valid data, use gTrack for live location, trip history, geofences and alerts. Fuel, ignition, temperature and other sensor values depend on the device, its wiring and firmware configuration.
Compare other ERM models or read the platform setup guide.
Other ERM models on starlink
ERM eBike · ERM IoTLink Shadow · ERM On BATT · ERM SMART Beacon SF · ERM SMART MS · ERM STaRLink AVL · ERM StarLink Asset · ERM StarLink EV
Questions and answers
Which server and port does the StarLink + CAN Bus use with gTrack?
Server tracker.uplisoft.com, port 5136, TCP, starlink protocol.
Do I need to buy the StarLink + CAN Bus from gTrack?
No. gTrack is tracking software: connect the StarLink + CAN Bus you already have.