gTrack
PlatformLive GPS trackingTrip history & playbackAlerts & event rulesReportsGeofencesFuel & sensorsDrivers & behaviourFleet maintenanceVideo telematicsRemote commandsMobile appAI gTrack assistantAPI & integrations
SolutionsTransport & logisticsDelivery & courierConstruction & machineryTaxi & passenger transportCorporate fleetsCar rentalCold chainPublic sector & utilities
DevicesPricing
ResourcesGetting startedFAQSecurity & privacyPartners & resellers
CompanyAbout gTrackContact & quotePrivacy policyTerms of service
Request a quote
DigitalMatter connection guide

DigitalMatter Oyster3 GPS tracking setup

Connect your DigitalMatter Oyster3 to gTrack on the dmt protocol. This page lists its server settings and what gTrack reads from it. gTrack provides tracking software and does not sell trackers.

Connection settings

DigitalMatter Oyster3 server and port

Tracker modelDigitalMatter Oyster3
Server / hostnametracker.uplisoft.com
Port5137
TransportTCP
Protocoldmt

Enter the hostname without https:// and keep the port in its separate setting. Select TCP in your tracker configuration. Use the APN supplied by your SIM provider and check that mobile data is available.

Setup

Add DigitalMatter Oyster3 to your fleet

  1. Add the vehicle

    In gTrack click + Asset, give it a name and choose the tracker model.

  2. Enter the identifier

    Use the IMEI or device identifier printed on your tracker. Add its SIM phone number and APN in the tracker form.

  3. Set the server

    Configure your tracker to send to tracker.uplisoft.com using the model’s port and TCP or UDP transport shown below.

  4. Drive

    The first position appears as soon as the tracker connects — usually within minutes.

In the tracker form, choose DigitalMatter Oyster3 and enter the identifier exactly as shown on your device. Saving these fields does not remotely reconfigure the tracker: apply the server settings using its manufacturer’s configuration tool or supported SMS commands.

Check the connection

From the first packet to the live map

Open the device Terminal in gTrack to check incoming packets and decoded reports. Confirm the identifier, APN, hostname, port and transport if the device remains offline. A device without a GPS fix may connect before it can show a valid position.

Once DigitalMatter Oyster3 sends valid data, use gTrack for live location, trip history, geofences and alerts. Fuel, ignition, temperature and other sensor values depend on the device, its wiring and firmware configuration.

Compare other DigitalMatter models or read the platform setup guide.

Similar models

Other DigitalMatter models on dmt

DigitalMatter Barra GPS · DigitalMatter Yabby3 · DigitalMatter Yabby Edge

FAQ

Questions and answers

Which server and port does the Oyster3 use with gTrack?

Server tracker.uplisoft.com, port 5137, TCP, dmt protocol.

Do I need to buy the Oyster3 from gTrack?

No. gTrack is tracking software: connect the Oyster3 you already have.